For all sheet metal parts, there is no doubt that there is a production process for it, which is often referred to as the whole process of machining. Because the structure of sheet metal parts is different, the production process may also vary, but basically the steps that will actually operate make us take a look together.
Designing a scheme and making a parts diagram of the sheet metal part, the function of the sheet metal processing of the chassis enclosure is to express the structure of the sheet metal part according to the cartography.
Draw an expansion programme. In other words, the sheet metal stamping process carries out the part with a complicated structure into a flat part.
There are many methods of undercutting, the key ones being the following categories
Cutting the raw material from the bottom of the bed. It applies the cutting bed to cut the full length and total width specifications of the spread. If there are holes and corners, the rotary press machine is fused with the die to punch the machine and produce the corners.
Cold punching with a press. Automatic punching machines are used to punch and process flat panel structures after the part has been on the plate for one or several processes. It is characterised by short running times, high efficiency, reduced production costs and is often used for mass production.
CNC machine downs. CNC undercutting must be programmed first with a CNC lathe processing program. Use CNC programming software to load the produced development design diagram into the CNC lathe machining CNC lathe identifiable process. It is made to follow this programming process step by step on a piece of stainless steel plate and stamped and machined to look like the structure of its tablet.
Laser undercutting. It applies a laser cutting method on a stainless steel plate to cut out the structural look of the tablet. Countersinking and tapping. The counter-edge, also known as the pull hole, means that a slightly larger hole is drawn in the smaller base hole and subsequently tapped in the pull hole. Doing it that way boosts its energy and prevents the tooth from slipping out. It is generally used in the production of sheet metal for furniture with relatively thin sheet metal.
Translated with www.DeepL.com/Translator (free version)
